LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Overhaul - 42RE Automatic Transmission) >> Output Shaft Rear Bearing >> Removal

Output Shaft Rear Bearing: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove overdrive unit from the vehicle. (Refer to OVERDRIVE UNIT  )
  2. Remove overdrive geartrain from housing.
  3. Remove snap-ring holding output shaft rear bearing into overdrive housing (Fig 1).
    Fig 1: Identifying Output Shaft Rear Bearing
    G02657664Courtesy of DAIMLERCHRYSLER CORP.
  4. Using a suitable driver inserted through the rear end of housing, drive bearing from housing.
scientia non olet · About LEMON Manuals