LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Overhaul - 42RE Automatic Transmission) >> Oil Pump >> Disassembly >> Reaction Shaft Support Bushing Removal

Reaction Shaft Support Bushing Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble Bushing Remover Tools SP-1191, 3633 and 5324 (Fig 1). Do not clamp any part of reaction shaft or support in vise.
    Fig 1: Replacing Reaction Shaft Support Bushing
    G02657657Courtesy of DAIMLERCHRYSLER CORP.
  2. Hold Cup Tool SP-3633 firmly against reaction shaft and thread remover SP-5324 into bushing as far as possible by hand. Then thread remover tool 3-4 additional turns into bushing with a wrench.
  3. Turn remover tool hex nut down against remover cup to pull bushing from shaft. Clean all chips from shaft after bushing removal.
  4. Lightly grip old bushing in vise or with pliers and back remover tool out of bushing.
  5. Assemble Bushing Installer Tools C-4171 and SP-5325 (Fig 1).
  6. Slide new bushing onto Installer Tool SP-5325.
  7. Position reaction shaft support upright on a clean smooth surface.
  8. Align bushing in bore. Then tap bushing into place until Bushing Installer SP-5325 bottoms.
  9. Clean reaction shaft support thoroughly after installing bushing.
scientia non olet · About LEMON Manuals