LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Overhaul - 42RE Automatic Transmission) >> Bands >> Adjustments >> Adjustment-Bands >> Front Band

Front Band

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers.

  1. Raise vehicle.
  2. Loosen band adjusting screw locknut (Fig 1). Then back locknut off 3-5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw threads if necessary.
    Fig 1: Loosening Band Adjusting Screw Locknut
    G02657607Courtesy of DAIMLERCHRYSLER CORP.
  3. Tighten band adjusting screw to 8 N.m (72 in. lbs.) torque with Inch Pound Torque Wrench C-3380-A, a 3-in. extension and appropriate Torx™ socket.
    CAUTION: If Adapter C-3705 is needed to reach the adjusting screw, tighten the screw to only 5 N.m (47-50 in. lbs.) torque.
  4. Back off front band adjusting screw 3 turns.
  5. Hold adjuster screw in position and tighten locknut to 41 N.m (30 ft. lbs.) torque.
  6. Lower vehicle.
scientia non olet · About LEMON Manuals