LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Power Steering Pump) >> Pump >> Installation >> Installation-Power Steering Pump -3.9L & 5.9L

Installation-Power Steering Pump -3.9L & 5.9L

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bracket on the pump and tighten bolts to 54 N.m (40 ft. lbs.).
  2. Install the pump pulley, (Refer to PULLEY  ).
  3. Install pump assembly on the engine block and tighten the bolts to 41 N.m (30 ft. lbs.).
  4. Install the battery ground wire and tighten nut to 41 N.m (30 ft. lbs.).
  5. Connect the fluid hoses to the pump.
  6. Install the serpentine drive belt, (Refer to DRIVE BELTS ).
  7. Fill the reservoir with power steering fluid, (Refer to STANDARD PROCEDURE-POWER STEERING PUMP-INITIAL OPERATION  ).
scientia non olet · About LEMON Manuals