LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Frame & Bumpers) >> Rear Bumper >> Installation

Rear Bumper: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place bumper on a suitable lifting device and raise into position.
  2. Engage license plate lamp wire connector from body wire harness, if equipped.
  3. Install bolts attaching inner bumper brackets to frame rails and tighten to 94 N.m (70 ft. lbs.).
  4. Remove lifting device.
scientia non olet · About LEMON Manuals