Front Bumper: Installation
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
When the front bumper is installed, there should be a 19 mm gap between the bumper and front fender.
- Place the bumper on a suitable lifting device and position the bumper at the vehicle.
- Install the bolts attaching front bumper to inner bumper bracket and tighten to 94 N.m (70 ft. lbs.).
- Connect the fog lamp electrical connectors, if equipped.
- Install push-in fasteners attaching air deflector to front bumper fascia.