LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine - 5.9L) >> Rear Mount >> Installation >> 2WD

Rear Mount: Installation: 2WD

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the engine support bracket was removed, position the bracket to the transmission extension (Figure). Tighten the bolts to 68 N.m (50 ft. lbs.) torque.
  2. Install the insulator onto crossmember. Tighten the stud nuts to 41 N.m (30 ft. lbs.) torque.
  3. Lower the transmission and engine while aligning the engine support bracket to the insulator.
  4. Install thru-bolt in bracket and insulator. Tighten thru-bolt nut to 68 N.m (50 ft. lbs.) torque.
  5. Remove transmission jack.
  6. Lower the vehicle.
  7. Connect the negative cable to the battery.
scientia non olet · About LEMON Manuals