LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine - 5.9L) >> Oil Pan >> Installation >> 4WD

Oil Pan: Installation: 4WD

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fabricate 4 alignment dowels from 1 1/2 x 5/16 inch bolts. Cut the head off the bolts and cut a slot into the top of the dowel. This will allow easier installation and removal with a screwdriver (Figure).
  2. Install the dowels in the cylinder block (Figure).
  3. Apply small amount of Mopar® Silicone Rubber Adhesive Sealant, or equivalent in the corner of the cap and the cylinder block.
  4. Slide the one-piece gasket over the dowels and onto the block.
  5. Position the oil pan over the dowels and onto the gasket.
  6. Install the oil pan bolts. Tighten the bolts to 24 N.m (215 in. lbs.) torque.
  7. Remove the dowels. Install the remaining oil pan bolts. Tighten these bolts to 24 N.m (215 in. lbs.) torque.
  8. Install the drain plug. Tighten drain plug to 34 N.m (25 ft. lbs.) torque.
  9. Install transmission inspection cover.
  10. Install engine mount support brackets and insulators (Refer to ENGINE/ENGINE MOUNTING/FRONT MOUNT-INSTALLATION ).
  11. Install front driving axle (Refer to FRONT AXLE-C205F ).
  12. Lower vehicle
  13. Connect the distributor cap.
  14. Install dipstick.
  15. Connect the negative cable to the battery.
  16. Fill crankcase with oil to proper level.
scientia non olet · About LEMON Manuals