LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine - 4.7L) >> Front Mount >> Installation

Front Mount: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the insulator mount and install the insulator mount through bolt.
  2. Lower the engine until the four cylinder block-to-insulator mount bolts can be installed.
  3. Remove the jack and block of wood.
  4. Torque the cylinder block-to-insulator mount bolts to 61 N.m ( 45 ft. lbs.).
  5. Install and torque the through bolt retaining nut to 61 N.m (45 ft. lbs.).
  6. Install the fan blade, fan clutch and fan shroud.
scientia non olet · About LEMON Manuals