LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine - 4.7L) >> Exhaust Manifold >> Removal >> Right Exhaust Manifold

Right Exhaust Manifold

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative cable for battery.
  2. Remove air cleaner assembly, resonator assembly and air inlet hose.
  3. Remove accessory drive belt (Refer to DRIVE BELTS ).
  4. Remove A/C compressor (Refer to A/C COMPRESSOR ).
  5. Remove A/C accumulator support bracket fastener.
  6. Drain coolant below heater hose level (Refer to STANDARD PROCEDURE-DRAINING COOLING SYSTEM 4.7L ).
  7. Remove heater hoses at engine.
  8. Remove fasteners attaching exhaust manifold heat shield.
  9. Remove heat shield.
  10. Remove upper exhaust manifold attaching fasteners.
  11. Raise vehicle on hoist.
  12. Disconnect exhaust pipe from manifold.
  13. Remove fasteners attaching starter. Move starter aside.
  14. Remove lower exhaust manifold attaching fasteners.
  15. Remove exhaust manifold and gasket (Fig 1). Manifold is removed from below the engine compartment.
    Fig 1: Removing Right Exhaust Manifold
    G02657072Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals