LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine - 4.7L) >> Cylinder Head Cover(S) >> Removal >> Removal-Right Side

Removal-Right Side

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery negative cable.
  2. Remove air cleaner assembly, resonator assembly and air inlet hose.
  3. Drain cooling system (Refer to STANDARD PROCEDURE-DRAINING COOLING SYSTEM 4.7L ).
  4. Remove accessory drive belt (Refer to DRIVE BELTS ).
  5. Remove air conditioning compressor retaining bolts and move compressor to the left.
  6. Remove heater hoses.
  7. Disconnect injector and ignition coil connectors.
  8. Disconnect and remove positive crankcase ventilation (PCV) hose.
  9. Remove oil fill tube.
  10. Un-clip injector and ignition coil harness and move away from cylinder head cover.
  11. Remove right rear breather tube and filter assembly.
  12. Remove cylinder head cover retaining bolts.
  13. Remove cylinder head cover.
NOTE: The gasket may be used again, provided no cuts, tears, or deformation has occurred.
scientia non olet · About LEMON Manuals