LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine - 3.9L) >> Front Mount >> Installation >> 4WD

Front Mount: Installation: 4WD

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. If engine support brackets were removed, install them and their fasteners. Tighten support bracket to block bolts to 41 N-m (30 ft. lbs.). Tighten support bracket to transmission bellhousing bolt(s) to 88 N-m (65 ft. lbs.)
  2. Install Engine mount insulator and tighten insulator to support bracket nut to 41 N-m (30 ft. lbs.). Tighten insulator to support bracket through bolt nut to 102 N-m (75 ft. lbs.)
    Fig 1: Installing Engine Mount
    G02656882Courtesy of DAIMLERCHRYSLER CORP.
  3. Lower engine and install insulator to frame through bolt and nut. Tighten nut to 95 N-m (70 ft. lbs.)
  4. Install starter motor and mounting bolts. Tighten bolts to 68 N-m (50 ft. lbs.)
  5. Connect starter wires.
  6. Remove engine lifting (support) fixture.
  7. Install front axle assembly (Refer to FRONT AXLE-C205F ).
  8. Lower the vehicle.
  9. Connect the negative cable to the battery.
scientia non olet · About LEMON Manuals