LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Wiper System & Washer System) >> Wiper Module >> Installation

Wiper Module: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper module into the cowl plenum as a unit.
  2. Reconnect the headlamp and dash wire harness ground connector to the wiper motor ground terminal (Figure ).
  3. Reconnect the headlamp and dash wire harness connector for the wiper motor to the wiper motor pigtail wire connector.
  4. Reach into the cowl plenum to align the wiper module mounting bracket with the locations for the mounting screws.
  5. Install and tighten the four screws that secure the wiper module bracket to the cowl plenum panel and the dash panel. Tighten the screws to 8 N.m (72 in. lbs.).
  6. Reinstall the cowl plenum cover/grille panel over the top of the cowl plenum. (Refer to COWL GRILLE ).
  7. Reconnect the battery negative cable.
  8. Close and latch the hood.
  9. Reinstall both wiper arms onto the wiper pivots. (Refer to WIPER ARM  ).
scientia non olet · About LEMON Manuals