Washer Fluid Level Switch: Installation
WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new rubber grommet seal into the washer fluid level switch mounting hole in the outboard side of the washer reservoir. Always use a new rubber grommet seal on the reservoir.
- Position the float of the washer fluid level switch through the rubber grommet seal in the washer reservoir (Figure ). The connector receptacle of the washer fluid level switch should be pointed downward.
- Press firmly and evenly on the washer fluid level switch using hand pressure until the barbed nipple is fully seated in the rubber grommet seal in the washer reservoir mounting hole.
- Reconnect the headlamp and dash wire harness connector for the washer fluid level switch to the switch connector receptacle.
- Reconnect the washer hose to the barbed outlet nipple of the washer pump/motor unit.
- Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
- Reconnect the battery negative cable.