LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Speed Control) >> Vacuum Reservoir >> Installation

Vacuum Reservoir: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The vacuum reservoir is located under the plastic cowl plenum cover at lower base of windshield (Figure ) or (Figure ).

  1. Install vacuum reservoir and three mounting screws to plastic cowl cover. Tighten three screws to 2.2 N.m (20 in. lbs.) torque.
  2. Position cowl plenum cover/grille panel to vehicle.
  3. Connect vacuum supply hose to vacuum reservoir.
  4. Connect windshield washer supply hose at inline connector.
  5. Install and tighten cowl cover fasteners to vehicle body.
  6. Install rubber weather-strip at front edge of cowl grill.
  7. Install windshield wiper arms. Refer to WIPER ARM .
  8. Connect negative battery to cable.
scientia non olet · About LEMON Manuals