LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Power Locks) >> Power Lock Switch >> Removal

Power Lock Switch: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The power lock switch on the driver side front door trim panel is integral to the driver door module. (Refer to DRIVER DOOR MODULE  ).

  1. Disconnect and isolate the battery negative cable.
  2. Using a trim stick or another suitable wide flat bladed tool and starting at the rear of the passenger door power window and lock switch bezel, gently pry the bezel up and out from the passenger side front door trim panel.
  3. Pull the power window and lock switch bezel away from the trim panel opening far enough to access the two switch connector receptacles on the back of the unit.
  4. Disconnect the door wire harness connectors for the power lock and power window switches from the switch connector receptacles.
  5. Remove the power window and lock switch bezel from the door trim panel.
  6. Using a small thin-bladed screwdriver, gently pry the snap clips at the sides of the power lock switch receptacle on the back of the power window and lock switch bezel and pull the switch out of the receptacle.
scientia non olet · About LEMON Manuals