LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Power Locks) >> Power Lock Switch >> Installation

Power Lock Switch: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The power lock switch on the driver side front door trim panel is integral to the driver door module. (Refer to DRIVER DOOR MODULE  ).

  1. Align the power lock switch with the receptacle on the back of the power window and lock switch bezel.
  2. Using hand pressure, gently and evenly press down on the power lock switch it snaps into place in the power window and lock switch bezel receptacle.
  3. Position the power window and lock switch bezel to the opening in the passenger side front door trim panel.
  4. Reconnect the two door wire harness connectors for the power window and power lock switches to the switch connector receptacles.
  5. Insert the front of the power window and lock switch bezel into the opening in the passenger side front door trim panel.
  6. Using hand pressure, gently and evenly press down on the rear of the power window and lock switch bezel until it snaps into place.
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals