LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Power Locks) >> Driver Door Module >> Installation

Driver Door Module: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the Driver Door Module (DDM) to the opening in the driver side front door trim panel.
  2. Reconnect the two door wire harness connectors for the DDM to the DDM connector receptacles.
  3. Insert the front of the DDM bezel into the opening in the driver side front door trim panel.
  4. Using hand pressure, gently and evenly press down on the rear of the DDM bezel until it snaps into place.
  5. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals