LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Power Locks) >> Door Cylinder Lock Switch >> Removal

Door Cylinder Lock Switch: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the door outside latch handle mounting hardware and linkage from the inside of the door. (Refer to EXTERIOR HANDLE ).
  3. From the outside of the door, pull the door outside latch handle out from the door far enough to access the door cylinder lock switch (Fig 1 ).
    Fig 1: Removing And Installing Door Cylinder Lock Switch
    G02656744Courtesy of DAIMLERCHRYSLER CORP.
  4. Disengage the door cylinder lock switch from the back of the lock cylinder.
  5. Disconnect the door cylinder lock switch pigtail wire connector from the door wire harness connector.
  6. Disengage the retainers that secure the door cylinder lock switch pigtail wire harness to the inner door panel.
  7. Remove the door cylinder lock switch from the door.
scientia non olet · About LEMON Manuals