LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Audio) >> Antenna Body & Cable >> Installation

Antenna Body & Cable: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the antenna body and cable in the opening between the right cowl side outer panel and the fender through the front door opening.
  2. Push the antenna coaxial cable into the passenger compartment through the hole in the right cowl side outer panel.
  3. Engage the antenna coaxial cable grommet in the hole in the right cowl side outer panel.
  4. Position the antenna body through the mounting hole in the top of the fender.
  5. Install the adapter over the antenna body from the top of the fender.
  6. Install and tighten the antenna cap nut using an antenna nut wrench (Special Tool C-4816). Tighten the antenna cap nut to 8 N.m (70 in. lbs.).
  7. Install and tighten the antenna mast onto the antenna body. Tighten the mast to 3.3 N.m (30 in. lbs.).
  8. Engage the antenna coaxial cable retainers at the right cowl side inner panel and inside the right front fender.
  9. Reach under the instrument panel outboard of the glove box to reconnect the antenna coaxial cable connector.
  10. Install the trim cover onto the right cowl side inner panel.
  11. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals