LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Brakes - Abs) >> Rear Wheel Speed Sensor >> Installation

Rear Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect harness to sensor. Be sure seal is securely in place between sensor and wiring connector. 
  2. Install O-ring on sensor (if removed).
  3. Insert sensor in differential housing.
  4. Install sensor shield.
  5. Install the sensor mounting stud and tighten to 24 N.m (200 in. lbs.).
  6. Install the brake line on the sensor stud and install the nut.
  7. Lower vehicle.
scientia non olet · About LEMON Manuals