LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Brakes - Abs) >> Front Wheel Speed Sensor >> Removal >> Removal-4X4

Front Wheel Speed Sensor: Removal: Removal-4X4

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Special bolts are used to attach the front sensor. The bolts have a special shoulder, thread length and surface treatment. If the original bolts must be replaced, use only factory replacement bolts. Do not use substitute bolt under any circumstances.
  1. Raise and support vehicle.
  2. Remove wheel and tire assembly.
  3. Remove brake caliper and rotor. (Refer to ROTOR (2003) or ROTOR (2004) ).
  4. Remove bolts attaching sensor to hub/bearing (Fig 1 ).
    Fig 1: Removing Front Wheel Speed Sensor - 4X4
    G02656395Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove clamps securing sensor wire to control arm and inner fender panel.
  6. In engine compartment, disconnect sensor wire and remove sensor.
scientia non olet · About LEMON Manuals