Front Wheel Speed Sensor: Installation: Installation-4X4
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Special bolts are used to attach the front sensor. The bolts have a special shoulder, thread length and surface treatment. If the original bolts must be replaced, use only factory replacement part. Do not use substitute bolts under any circumstances.
- Guide sensor wire around upper control arm.
- Position sensor on hub/bearing and install attaching bolts. Tighten bolt to 18-25 N.m (160-220 in. lbs.).
- Secure sensor wire retaining clamps to control arm and fender panel with original hardware.
- In engine compartment, connect sensor wire to harness connector. Insure wire is routed away from hot or rotating underhood components.
- Install brake rotor and caliper. (Refer to ROTOR (2003) or ROTOR (2004) ).
- Install wheel and tire assembly. (Refer to STANDARD PROCEDURE (2003) or TIRES/WHEELS (2004)).
- Turn steering wheel back and forth to verify that wire is clear of steering and suspension components.
- Remove supports and lower vehicle.