Front Wheel Speed Sensor: Installation: Installation-4X2
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Special bolts are used to attach the front sensor. The bolts have a special shoulder, thread length and surface treatment. If the original bolts must be replaced, use only factory replacement part. Do not use substitute bolts under any circumstances.
- Position sensor in the knuckle (Figure ) and install sensor attaching bolts. Tighten bolts to 21 N.m (190 in. lbs.).
- Secure sensor wire retaining clamps to control arm and fender panel.
- In engine compartment, connect sensor wire to harness connector. Make sure wire is routed away from hot or rotating underhood components.
- Turn steering wheel back and forth to verify that wire is clear of steering and suspension components.
- Remove supports and lower vehicle.