LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Front Axle - C205F) >> Front Axle-C205F >> Installation

Front Axle-C205F: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the axle into position. Loosely install the bolts and nuts to hold the axle to the engine mounts and pinion nose bracket.
  2. Tighten all the bolts finger-tight, then tighten all bolts to 95 N.m (70 ft. lbs.).
  3. Install the axle vent tube.
  4. Align the reference marks on the propeller shaft, transfer case, and pinion companion flange.
  5. Install propeller shaft.
  6. Install half shafts.
  7. Install skid plate support crossmember, if necessary.
  8. Install skid plate, if necessary.
  9. Check differential lubricant level and add lubricant, if necessary.
  10. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals