LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Propeller Shaft) >> Propeller Shaft-Rear >> Installation

Propeller Shaft-Rear: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide the slip yoke onto the transmission, or transfer case, output shaft.
  2. Align and install the center bearing and heat shield to the support bracket, if necessary. Install the bolts and tighten to 68 N.m (50 ft. lbs.).
  3. Align companion flange reference mark with flange yoke mark.
  4. Install companion flange bolts and tighten to 108 N.m (80 ft. lbs.).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals