LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Propeller Shaft) >> Center Bearing >> Removal

Center Bearing: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear propeller shaft.
  2. Remove slip joint boot clamp and separate the two half-shafts.
  3. Use hammer and punch to tap slinger away from shaft to provide room for bearing splitter.
  4. Position Bearing Splitter Tool 1130 between slinger and shaft.
    CAUTION: Do not damage shaft spline during removal of center bearing.
  5. Set shaft in press and press bearing off the shaft.
scientia non olet · About LEMON Manuals