LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Propeller Shaft) >> Center Bearing >> Installation

Center Bearing: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new slinger on shaft and drive into position with appropriate installer tool.
  2. Install new center bearing on shaft with Bearing Installer Tool 6052. Drive on shaft with hammer until bearing is seated.
  3. Clean shaft splines and apply a coat of multipurpose grease.
  4. Align master splines and slide front and rear half-shafts together. Reposition slip yoke boot and install new clamp.
  5. Install propeller shaft in vehicle.
scientia non olet · About LEMON Manuals