Air Bag System Check
WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform following check after component replacement.
- With battery disconnected, connect DRBIII scan tool to Data Link Connector (DLC), located under left side of instrument panel, near steering column. See Fig 1. Turn ignition switch to ON position and exit vehicle with scan tool.
- Ensure no one is in vehicle, then connect negative battery cable. Using scan tool, read and record all active and stored DTCs. If any DTCs are present, go to DIAGNOSTICS . If no DTCs are present, perform DRBIII diagnostic trouble code erase function (active DTCs will not erase). Go to AIR BAG WARNING LIGHT CHECK .