LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Air Bag Restraint Systems) >> Removal & Installation >> Air Bag Control Module (ACM) >> Removal

Air Bag Control Module (ACM): Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove floor duct adapter retaining screw from bottom of AC-heater unit housing (under instrument panel) and remove adapter. Pull carpet away from right and left sides of transmission tunnel under center of instrument panel.
  3. Remove 4 ACM retaining screws and lift ACM up and off locating pins. See Figure. Disconnect ACM wire harness connector and remove ACM.
scientia non olet · About LEMON Manuals