LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Generators & Regulators) >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes

Retrieving Diagnostic Trouble Codes

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before entering self-diagnostics, check charging system for other problems. See TROUBLE SHOOTING . DO NOT connect scan tool to vehicle if battery charger is connected, as scan tool damage will result.
NOTE: Powertrain Control Module (PCM) cannot diagnose every charging system problem. If fault still exists after performing self-diagnostic procedures, perform ON-VEHICLE TESTING .
NOTE: Diagnostic tests are written specifically for Chrysler's Diagnostic Readout Box (DRB-III®) scan tool. A generic scan tool may also be used for system diagnostics, but may have limited diagnostic capability.
NOTE: For more information on scan tool and Powertrain Control Module (PCM) diagnostics, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.

Ensure battery is fully charged. Connect scan tool to Data Link Connector (DLC). DLC is located below instrument panel, near steering column. Using scan tool, retrieve and record DTCs. If scan tool does not communicate with all modules, repair communication concerns. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. If any DTCs are retrieved, perform appropriate test procedure in accordance with DTCs retrieved. See SCAN TOOL DTC MESSAGES  table. Once repairs are made, clear DTCs from Powertrain Control Module (PCM) memory. See CLEARING DIAGNOSTIC TROUBLE CODES . If no DTCs are retrieved, perform CHECKING CHARGING SYSTEM OPERATION WITH NO DTC'S  under SYSTEM TESTS.

SCAN TOOL DTC MESSAGES

DTC (1) Scan Tool Display
P0070  AMBIENT TEMP SENSOR STUCK (NGC)
P0071  AMBIENT/BATTERY TEMP SENSOR PERFORMANCE (GAS)
P0071  AMBIENT TEMP SENSOR PERFORMANCE (NGC)
P0072  AMBIENT TEMP SENSOR CIRCUIT LOW
P0073  AMBIENT TEMP SENSOR CIRCUIT HIGH
P0516  BATTERY TEMPERATURE SENSOR LOW
P0517  BATTERY TEMPERATURE SENSOR HIGH
P0562  BATTERY VOLTAGE LOW
P0563  BATTERY VOLTAGE HIGH
P0622  GENERATOR FIELD NOT SWITCHING PROPERLY (GAS)
P0622  GENERATOR FIELD CONTROL CIRCUIT (NGC)
P1492  AMBIENT/BATTERY TEMPERATURE SENSOR VOLTAGE TOO HIGH
P1493  AMBIENT BATTERY TEMPERATURE SENSOR VOLTAGE TOO LOW
P1594  CHARGING SYSTEM VOLTAGE TOO HIGH
P1682  CHARGING SYSTEM VOLTAGE TOO LOW
P2503  CHARGING SYSTEM OUTPUT LOW
(1) DTCs listed in this table are only testing procedures covered in this article. For a complete listing of PCM DTCs, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.