LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Starter System) >> Removal & Installation >> Starter >> Installation (4.7L V-8 With Manual Transmission)

Installation (4.7L V-8 With Manual Transmission)

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position starter motor to transmission housing.
  2. Connect battery cable solenoid terminal wire harness connector to connector receptacle on starter solenoid. Always support the starter motor during this process. Do not let the starter motor hang from the wire harness.
  3. Install battery cable eyelet terminal onto solenoid B(+) terminal stud.
  4. Install and tighten nut securing battery cable eyelet terminal to starter solenoid B(+) terminal stud. Tighten nut to specification. See TORQUE SPECIFICATIONS  .
  5. Position starter motor over stud on transmission housing.
  6. If equipped with automatic transmission, slide automatic transmission cooler tube bracket rearward on tubes and into position over starter motor flange.
  7. Loosely install the washers, bolt, and nut to starter. Tighten bolt and nut to specification. See TORQUE SPECIFICATIONS  .
  8. Lower vehicle.
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals