LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Overhaul >> Wheel Cylinder >> Assembly

Wheel Cylinder: Assembly

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate wheel cylinder bore, pistons, piston cups, spring, and expander with clean brake fluid.
  2. Install first piston in cylinder bore. Then install first cup in bore and against piston. Be sure lip of piston cup is facing inward (toward spring and expander) and flat side is against piston.
  3. Install spring and expander followed by remaining piston cup.
  4. Install boots on each end of cylinder and insert push rods in boots.
  5. Install cylinder bleed screw.
scientia non olet · About LEMON Manuals