Torque Specifications
WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Compressor Shaft Hex Nut | 11-15 (15-20) |
| Compressor Mounting Bolts (3.9L, & 5.9L) | 30 (41) |
| Compressor Mounting Bracket (3.9L & 5.9L) | 20 (27) |
| Compressor Mounting Bolts Mounting Ear Screw (4.7L) | 41 (55) |
| Compressor Mounting Bolt Long Screw (4.7L) | 30 (40) |
| Compressor Mounting Bolt Rear Screw (4.7L) | 41 (55) |
| Compressor Shaft Hex Nut | 11-15 (15-20) |
| Discharge Line-To-Condenser Inlet Fitting | 14-19 (19-26) |
| Liquid Line-To-Condenser Outlet Fitting | 14-19 (19-26) |
| Refrigerant Line Couplers-To-Condenser & Accumulator | 14-19 (19-26) |
| Refrigerant Lines At Compressor | 17 (23) |
| Refrigerant Line Manifold-To-Compressor Mounting Screws | 14-19 (19-26) |
| TXV Retaining Bolts | 13 (18) |
| INCH Lbs. (N.m) | |
| Accumulator Retaining Band Screw | 40 (4.5) |
| A/C Heater Control-To-Cluster Bezel In Instrument Panel Screws | 14-20 (1.6-2.3) |
| Ambient Temperature Sensor Bracket-To-Radiator Yoke Screw | 50 (5.6) |
| Blend Door Actuator-To-Distribution Housing | 18 (2) |
| Blower Motor Resistor Block-To-HVAC Unit | 20 (2.2) |
| Blower Motor & Blower Wheel Assembly-To-HVAC Housing | 20 (2.2) |
| HVAC Housing Mounting Nuts-To-Engine Compartment Side Of Dash Panel | 62 (7) |
| Mode Door Actuator-To-Distribution Housing Screws | 18 (2) |
| Recirculation Door Actuator-To-Lower Air Intake Housing Screws | 18 (2) |
| Refrigerant Line Support Bracket Mounting Screws | 45-75 (5.1-8.5) |
| Resistor-To-HVAC Unit Screws | 20 (2.2) |