LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Self Diagnostics - 4.7L) >> Diagnostic Tests >> DTC P0630: VIN Not Programmed In Pcm >> Testing

DTC P0630: VIN Not Programmed In Pcm: Testing

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition on, engine not running. With the DRBIII® scan tool erase DTCs. Using the DRBIII® scan tool, program VIN into the PCM. Start the engine. If the engine will not start, crank the engine over for 15 seconds. Crank at least 2 times with the ignition switch returning to the off position each time. Allow the engine to reach normal operating temperature. With the DRBIII® scan tool, read DTCs. Does the DTC reset? If yes, replace and program the PCM. See PROGRAMMING . If no, the VIN has been successfully programmed into the PCM. Test is complete.
scientia non olet · About LEMON Manuals