LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Emission Controls & Evaporative Emissions) >> Emissions Control >> Description >> Description - Diagnostic Trouble Codes >> Obtaining DTC'S Using DRB Scan Tool

Obtaining DTC'S Using DRB Scan Tool

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Obtain the applicable Powertrain Diagnostic Manual.
  2. Obtain the DRB Scan Tool.
  3. Connect the DRB Scan Tool to the data link (diagnostic) connector. This connector is located in the passenger compartment; at the lower edge of instrument panel; near the steering column.
  4. Turn the ignition switch on and access the "Read Fault" screen.
  5. Record all the DTC's and "freeze frame" information shown on the DRB scan tool.
  6. To erase DTC's, use the "Erase Trouble Code" data screen on the DRB scan tool. Do not erase any DTC's until problems have been investigated and repairs have been performed. 
scientia non olet · About LEMON Manuals