LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Power Distribution) >> IOD Fuse >> Installation

IOD Fuse: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The Ignition-Off Draw (IOD) fuse is disconnected from Junction Block (JB) fuse cavity 12 when the vehicle is shipped from the assembly plant. Dealer personnel must reconnect the IOD fuse when the vehicle is being prepared for delivery in order to restore full electrical system operation.

  1. Turn the ignition switch to the Off position.
  2. Remove the fuse access panel by unsnapping it from the left outboard end of the instrument panel.
  3. To install the IOD fuse, use a thumb to press the IOD fuse holder unit in fuse cavity 12 firmly into the JB.
  4. Install the fuse access panel by snapping it onto the left outboard end of the instrument panel.
scientia non olet · About LEMON Manuals