LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Power Distribution) >> Generator Cartridge Fuse >> Installation

Generator Cartridge Fuse: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

If a generator cartridge fuse fails, be certain to inspect and test the vehicle charging system before replacing the cartridge fuse and returning the vehicle to service. Refer to SYSTEM WIRING DIAGRAMS for the charging system diagnostic procedures.

  1. Position the generator cartridge fuse onto the two B(+) terminal stud bus bars within the PDC.
  2. Install and tighten the two screws that secure the generator cartridge fuse to the two B(+) terminal stud bus bars within the PDC. Tighten, the screws to 3.4 N.m (30 in. lbs.). Be certain that both screws are tightened to the proper torque value. 
  3. Install and latch the cover onto the PDC.
  4. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals