LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Fuel Injection) >> O2 Sensor >> Installation >> Installation - 4.7L

Installation - 4.7L

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to the threads of a new oxygen sensor. 

  1. Install the O2S sensor. Tighten to 30 N.m (22 ft. lbs.) torque.
  2. Connect the;O2S.sensor wire connector.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals