LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (HVAC - Plumbing) >> A/C Evaporator >> Installation

A/C Evaporator: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only refrigerant oil of the type recommended for the compressor in the vehicle.
  1. Install the A/C evaporator into the HVAC housing. Make sure that the evaporator drain is clean and unrestricted and that the evaporator deflector shield is installed.
  2. Install the evaporator temperature sensor probe into the A/C evaporator.
    Fig 1: Identifying A/C Evaporator
    G03489478Courtesy of DAIMLERCHRYSLER CORP.
  3. Assemble the HVAC housing (Refer to HVAC HOUSING ).
  4. Install the HVAC housing (Refer to HVAC HOUSING ).
scientia non olet · About LEMON Manuals