LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Air Bag Restraint Systems) >> Removal & Installation >> Air Bag Control Module (ACM) >> Removal

Air Bag Control Module (ACM): Removal

WARNING: This page is about a different car, the 2002 Dodge Durango and 2002 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Remove floor duct adapter retaining screw from bottom or AC-heater unit housing (under instrument panel) and remove adapter. Pull carpet away from right and left sides of transmission tunnel under center of instrument panel.
  3. Remove 4 ACM retaining screws and lift ACM up and off locating pins. See Figure . Disconnect ACM wire harness connector and remove ACM.
scientia non olet · About LEMON Manuals