Installation (Durango)

Push each cable housing through the brake support plate hole until cable housing retainer tabs lock into place.
NOTE: Pull on the cable housing to ensure it is locked into place.
Pull back on the end of the cable. Then push the cable in to engage the cable in the parking brake lever.
NOTE: Pull on the end to ensure the cable is attached to the parking brake lever.
Install the brake drums.
Install right cable mounting retainers.
Push the cable housing through the cable bracket.
Install left cable onto the cable connector.
Push the right cable housing the left cable connector and connect the cable to the tensioner.
Install the wheel and tire assemblies. See TORQUE SPECIFICATIONS .
Perform parking brake adjustment procedures. See PARKING BRAKE CABLES under ADJUSTMENTS.
Remove support and lower the vehicle