LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Neon Base, Automatic >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Disc Brake Shoes >> Removal (Rear - All Models)

Removal (Rear - All Models)

  1. Raise the vehicle.
  2. Remove the rear tire and wheel assembly.
  3. Remove rear caliper from the caliper adapter. See CALIPER  .
  4. Remove the outboard brake shoe from the caliper by prying the brake shoe retaining slip over the raised area on the caliper. Then slide the brake shoe down and off the brake caliper. See Fig 1 .
  5. Pull the inboard brake shoe away from the caliper piston until the retaining clip is free from the cavity in the piston. See Fig 2 .
Fig 1: Removing & Installing Outboard Disc Brake Shoe (Rear - All Models)
G00309429Courtesy of CHRYSLER CORP.
Fig 2: Removing & Installing Inboard Disc Brake Shoe (Rear - All Models)
G00309430Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals