LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Neon Base, Automatic >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Fluid Reservoir >> Installation

Brake Fluid Reservoir: Installation

  1. Install NEW sealing grommets (O-rings) with fresh clean DOT 3 brake fluid. Place the reservoir in position over the grommets making sure the filler hole is towards the front of the vehicle. Seat the reservoir into the grommets. Install new plastic NEW plastic pins through their mounting holes until they protrude out the other side of the master cylinder reservoir. See Figure .
  2. Connect the brake fluid level switch wiring harness connector. See Figure .
  3. Fill the reservoir with clean DOT 3 brake fluid. See CHECKING & FILLING  under BRAKE FLUID in SERVICE.
scientia non olet · About LEMON Manuals