Removal & Installation
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
Locate input and output speed sensors located on left side of transaxle. See Fig 1. Disconnect harness connector of sensor to be replaced. Remove sensor. Inspect sensor "O" ring and replace as necessary. To install, reverse removal procedure. Tighten sensor(s) to specification. See TORQUE SPECIFICATIONS .