LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Intrepid SE, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Controls - Removal, Overhaul & Installation) >> Sensors & Switches >> Camshaft Position Sensor >> Removal (2.7L)

Removal (2.7L)

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Camshaft Position (CMP) sensor is located on front of driver's side cylinder head. See Figure.
  2. Disconnect CMP sensor harness connector. Remove CMP sensor bolt. Pull CMP sensor upward and out of timing chain cover.
scientia non olet · About LEMON Manuals