LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Intrepid SE, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Controls - Removal, Overhaul & Installation) >> Sensors & Switches >> Camshaft Position Sensor >> Installation (3.5L)

Installation (3.5L)

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. If reusing CMP sensor, clean old paper spacer from camshaft end of CMP sensor. Install NEW paper spacer on camshaft end of CMP sensor.
  2. On all CMP sensors, install CMP sensor in timing belt housing. Push CMP sensor downward until it contacts camshaft sprocket.
  3. Install and tighten bolt for CMP sensor to specification while holding CMP sensor downward against camshaft sprocket. See TORQUE SPECIFICATIONS . Install CMP sensor harness connector. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals