LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Intrepid SE, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Injector >> Removal (2.7L)

Removal (2.7L)

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel systems pressure. See FUEL LINE DISCONNECT FITTINGS . Disconnect negative cable to battery.
  2. Remove intake manifold plenum mounting bolts. Lift Plenum up off of engine.
  3. Cover intake manifold to prevent foreign material from entering engine.
  4. Disconnect fuel supply tube quick connect fittings at the rear of intake manifold. See FUEL LINE DISCONNECT FITTINGS .
  5. If the injector connectors are not tagged with their cylinder number, tag them to identify the correct cylinder. Remove electrical connectors from the fuel injectors.
  6. Remove fuel rail mounting bolts. Lift fuel rail straight up off of the cylinder head. Remove retaining clips from fuel injectors at fuel rail. Remove fuel injectors.
  7. Repeat for remaining injectors. Check injector "O" ring for damage. If "O" ring is damaged, it must be replaced. Replace the injector clip if it is damage.
scientia non olet · About LEMON Manuals