LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Intrepid SE, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Controls - Removal, Overhaul & Installation) >> Emission Systems & Sub-Systems >> Natural Vacuum Leak Detection Assembly >> Removal

Natural Vacuum Leak Detection Assembly: Removal

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. NVLD assembly is located on EVAP canister above fuel tank. See Figure. Disconnect negative battery cable at remote battery terminal on passenger's side strut tower. Remove fuel tank. See FUEL TANK  under FUEL SYSTEMS.
  2. Disconnect NVLD assembly harness connector. Disconnect hoses from NVLD assembly. Lift lock tab on NVLD assembly and twist the assembly counterclockwise. Pull up to remove NVLD assembly from EVAP canister. See Figure. Remove "O" ring from EVAP canister.
scientia non olet · About LEMON Manuals