LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Intrepid SE, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Controls - Removal, Overhaul & Installation) >> Emission Systems & Sub-Systems >> EVAP Canister >> Installation

EVAP Canister: Installation

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP canister to the upper mounting bracket. Swing EVAP canister into the lower mounting bracket and snap into place.
  2. Install the hoses to the top of the EVAP canister. Connect the electrical connector.
  3. Install the fuel tank. See FUEL TANK  under FUEL SYSTEMS. Connect the negative battery cable.
Fig 1: Disconnecting EVAP Canister Hoses
G00222034Courtesy of CHRYSLER CORP.
Fig 2: Locating EVAP Canister Top Tab
G00222035Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals